Pmod interface (peripheral module interface) is an open standard defined by Digilent in the Pmod Interface Specification^[1] for connecting peripheral modules to FPGA and microcontroller development boards using 6 pins. Pmod or Pmods may also refer to modules compatible with the Pmod interface.

Pmods are available from simple push buttons to more complex modules with network interfaces, analog to digital converters or LCD displays. These modules can be used with a variety of FPGA or microcontroller development boards from different vendors. The Pmod interface is designed so Pmods can be quickly connected to host boards for prototyping or evaluation purposes without soldering, but Pmods aren't quite plug and play since software and configuration is required.

Pmods come with a standard 6-pin interface of 4 signals, one ground and one power pin. Double and quad Pmods also exist. These duplicate the standard interface to allow more signals to pass through to the module.

Pmods can use either SPI, I²C or UART protocol. With I²C it is possible to use a 4-pin connector. Alternatively the pins 1 to 4 can be used as simple digital I/O pins.

Digilent was founded in 2000 by two Washington State University electrical engineering professors.^[2]

In 2011, v1.0.0 of Pmod Interface Specification was released.^[3]

In January 2013, National Instruments acquired all outstanding shares of Digilent Inc., which became a wholly owned subsidiary.^[4]

• Asynchronous serial bus such as RS-232 and RS-422.
• UEXT, a similar "Universal EXTension" connector format also for UART, I²C, and SPI, although separately over 10 wires in a 2x5 layout.