The three Ardent-class torpedo boat destroyers ("Thornycroft 27-knot (50 km/h) ") were ordered by the British Admiralty on 12 October 1893 ^[1] and served with the Royal Navy. Built by Thornycroft for a contract price of £110,520 for all three vessels, they displaced 301 tons fully laden, and were 201 feet 8 inches (61.47 m) long overall.

Quick Facts Class overview, General characteristics ...

HMS Ardent
Class overview
Name	Ardent class
Builders	Thornycroft, Church Wharf, Chiswick
Operators	Royal Navy
Preceded by	Ferret class
Succeeded by	Charger class
Built	1893-1895
In commission	1895–1918
Completed	3
Lost	1
Retired	2
General characteristics
Type	Torpedo boat destroyer
Displacement	245 long tons (249 t) (light); 301 long tons (306 t) (full load)
Length	201 ft 8 in (61.47 m) (overall); 201 ft 6 in (61.42 m) (waterline)
Beam	19 ft (5.8 m) (overall)
Draught	7 ft 3.25 in (2.2162 m)
Depth	13 ft (4.0 m)
Propulsion	Triple expansion steam engines Coal-fired water-tube boilers
Complement	50
Armament	1 × 12-pounder gun 5 × 6-pounder guns 2 × 18 inch (450 mm) torpedo tubes

Close

As part of the 1893–1894 Naval Estimates, the British Admiralty placed orders for 36 torpedo-boat destroyers, all to be capable of 27 knots (50 km/h; 31 mph), the "27-Knotters", as a follow-on to the six prototype "26-knotters" ordered in the previous 1892–1893 Estimates. As was typical for torpedo craft at the time, the Admiralty left detailed design to the builders, laying down only broad requirements.^[2][3]

The Ardent-class were derived from the preceding 26-knot (48 km/h) Daring class,^[4] but were larger and more powerfully engined. It was originally intended that they would be armed with one 12-pounder quick-firing gun forward and three 6-pounder guns, mounted on the broadside and aft, and three 18-inch torpedo tubes, one fixed in a bow mount and two on a revolving mount abaft the two funnels;^[5] however the fixed bow tube fitted in the preceding '26-knotter' type had subsequently been found to throw up too much spray and was removed, and in October 1893 it was agreed that the bow tube should be omitted, giving "a clean sharp stem with no projections"^[6] and instead two extra 6-pounder guns were installed en echelon amidships. These three ships - and the similar three Charger Class destroyers (ordered from Yarrow in the same week) - were the first TBDs to omit this fixed bow tube. They carried a complement of 2 officers and 48 ratings (comprising 20 deck department and 28 engine room compartment).^[7]

These three ship met the speed requirement of 27 knots for which they were designed. Over the measured mile and in three-hour trials they averaged the following power (ihp) and speed:

At her second preliminary trial, Ardent reached 29 knots with 407 r.p.m., the engines developing 5,044 ihp. However, Boxer was the fastest British destroyer among all the 27-knotters, her best run over the measured mile being 30¾ knots.

In September 1913 the Admiralty re-classed all the remaining 27-knotter destroyers as A Class; this applied to both Boxer and Bruiser, although the Ardent herself had already been scrapped. Bruiser was sold for scrap eight months later, prior to the start of WW1, while Boxer was the oldest destroyer in service in the Royal Navy during the First World War, although the oldest destroyer-type vessel was the large 'torpedo boat/torpedo boat chaser' TB.81 (ex-Swift), a destroyer precursor.