Aggressive_Link_Power_Management

Aggressive Link Power Management

Aggressive Link Power Management

Add article description


Aggressive Link Power Management (ALPM) is a power management protocol for Advanced Host Controller Interface-compliant (AHCI) Serial ATA (SATA) devices, such as hard disk drives and solid-state drives.[1]

Description

When enabled via the AHCI controller, this allows the SATA host bus adapter to enter a low-power state during periods of inactivity, thus saving energy. The drawback to this is increased periodic latency as the drive must be re-activated and brought back on-line before it can be used, and this will often appear as a delay to the end-user.

States

There are three states:[2]

  • Active
  • Low Power with two internal states Partial and Slumber. Partial has a maximum return latency of 10 microseconds while slumber has a maximum latency of 10 milliseconds. The states can be initiated by Host (HIPM), Device (DIPM) or both. Hot swapping is disabled.
  • Device Sleep with a maximum return latency of 20 milliseconds unless otherwise specified in Identify Data Log

These can be selected by the SATA AHCI driver, usually via a configuration option, or by the OS Power Options. Windows Vista and later allows the tweaking of AHCI LPM modes through a registry hack.[3] Hot swapping is disabled.

See also


References

  1. "Serial ATA AHCI: Specification, Rev. 1.3". Intel. Retrieved 31 October 2012.
  2. "Designing Energy Efficient SATA Devices" (PDF). Intel. Retrieved 31 October 2012.



Share this article:

This article uses material from the Wikipedia article Aggressive_Link_Power_Management, and is written by contributors. Text is available under a CC BY-SA 4.0 International License; additional terms may apply. Images, videos and audio are available under their respective licenses.