IEEE_802.16

IEEE 802.16

IEEE 802.16

Series of wireless broadband standards

IEEE 802.16 is a series of wireless broadband standards written by the Institute of Electrical and Electronics Engineers (IEEE). The IEEE Standards Board established a working group in 1999 to develop standards for broadband for wireless metropolitan area networks. The Workgroup is a unit of the IEEE 802 local area network and metropolitan area network standards committee.

Quick Facts

Although the 802.16 family of standards is officially called WirelessMAN in IEEE, it has been commercialized under the name "WiMAX" (from "Worldwide Interoperability for Microwave Access") by the WiMAX Forum industry alliance. The Forum promotes and certifies compatibility and interoperability of products based on the IEEE 802.16 standards.

The 802.16e-2005 amendment was implemented and deployed around the world as of 2009.[1] The version IEEE 802.16-2009 was amended by IEEE 802.16j-2009.

Standards

Projects publish draft and proposed standards with the letter "P" prefixed. Once a standard is ratified and published, that "P" gets dropped and replaced by a trailing dash and suffix year of publication.

Projects

More information Standard, Description ...

802.16e-2005 Technology

The 802.16 standard essentially standardizes two aspects of the air interface – the physical layer (PHY) and the media access control (MAC) layer. This section provides an overview of the technology employed in these two layers in the mobile 802.16e specification.

PHY

802.16e uses scalable OFDMA to carry data, supporting channel bandwidths of between 1.25 MHz and 20 MHz, with up to 2048 subcarriers. It supports adaptive modulation and coding, so that in conditions of good signal, a highly efficient 64 QAM coding scheme is used, whereas when the signal is poorer, a more robust BPSK coding mechanism is used. In intermediate conditions, 16 QAM and QPSK can also be employed. Other PHY features include support for multiple-input multiple-output (MIMO) antennas in order to provide good non-line-of-sight propagation (NLOS) characteristics (or higher bandwidth) and hybrid automatic repeat request (HARQ) for good error correction performance.

Although the standards allow operation in any band from 2 to 66 GHz, mobile operation is best in the lower bands which are also the most crowded, and therefore most expensive.[3]

MAC

The 802.16 MAC describes a number of Convergence Sublayers which describe how wireline technologies such as Ethernet, Asynchronous Transfer Mode (ATM) and Internet Protocol (IP) are encapsulated on the air interface, and how data is classified, etc. It also describes how secure communications are delivered, by using secure key exchange during authentication, and encryption using Advanced Encryption Standard (AES) or Data Encryption Standard (DES) during data transfer. Further features of the MAC layer include power saving mechanisms (using sleep mode and idle mode) and handover mechanisms.

A key feature of 802.16 is that it is a connection-oriented technology. The subscriber station (SS) cannot transmit data until it has been allocated a channel by the base station (BS). This allows 802.16e to provide strong support for quality of service (QoS).

QoS

Quality of service (QoS) in 802.16e is supported by allocating each connection between the SS and the BS (called a service flow in 802.16 terminology) to a specific QoS class. In 802.16e, there are 5 QoS classes:

More information Service, Abbrev ...

The BS and the SS use a service flow with an appropriate QoS class (plus other parameters, such as bandwidth and delay) to ensure that application data receives QoS treatment appropriate to the application.

Certification

Because the IEEE only sets specifications but does not test equipment for compliance with them, the WiMAX Forum runs a certification program wherein members pay for certification. WiMAX certification by this group is intended to guarantee compliance with the standard and interoperability with equipment from other manufacturers. The mission of the Forum is to promote and certify compatibility and interoperability of broadband wireless products.

See also

References

  1. [1]
    "WiMAX™ operators and vendors from around the world announce new deployments, growing commitments at the 2nd Annual WiMAX Forum® Global Congress". News release. WiMAX Forum. June 4, 2009. Archived from the original on July 17, 2011. Retrieved August 20, 2011.
  2. [2]
    "IEEE Approves IEEE 802.16m – Advanced Mobile Broadband Wireless Standard". News release. IEEE Standards Association. March 31, 2011. Retrieved August 20, 2011.
  3. [3]
    Michael Richardson; Patrick Ryan (March 19, 2006). "WiMAX: Opportunity or Hype?". Advances in Telecom: Proceedings of the Fourth Annual ITERA Conference. SSRN 892260.
Share this article:

This article uses material from the Wikipedia article IEEE_802.16, and is written by contributors. Text is available under a CC BY-SA 4.0 International License; additional terms may apply. Images, videos and audio are available under their respective licenses.